Datalogic Scanning M8300 Manual De Usuario

MESSAGE FORMATTING 

•  The cursor row  position  is not affected by the currently selected font. The 

display always has 4 rows, so when writing with the large font, actually two rows 
are written to: the current one and the one below it. You will need two ESC E 
commands to step from one row to the next when using the large font. 

 

•  The cursor column position is affected by the currently selected font. Therefore, 

column 6 is 36 pixels from the left border only if you last selected the 6x8 font; 
otherwise it could be 48 or 72 pixels from the left border. 

 
 

 

Normal mode 

Reverse mode 

Large font: subsequent characters are written on the current row and 
the row below it using the 12x16 font which allows for two rows of 
eight characters on the display. 

Normal font: subsequent characters are written using the 6x8 font, 
which allows for four rows of sixteen characters on the display. 

Medium font: subsequent characters are written using the 8x8 font, 
which allows for four rows of twelve characters on the display. 

 
 

 

From cursor position to end of line inclusive 

From beginning of line to cursor position (not inclusive) 

Entire line 

From cursor position to end of display inclusive 

From beginning of display to cursor position (not inclusive) 

Entire display; moves cursor to upper left corner on display 

 
 

 

Emit short High tone + short delay 

Emit short Low tone + short delay 

Emit long Low tone + short delay 

Emit good read tone 

Emit bad tx tone 

Wait 100 ms 

Turn on the green LED 

Turn off the green LED 

Turn on the red LED 

Turn off the red LED