Jacuzzi J-345 Manuel D’Utilisation

31

Included within the Primary Filtration Menu, is the Change Filter feature. 

To make changes to the change filter timer or to reset it, follow the steps 

below.

A.  Press the 

Menu ( 

 ) button once to enter the Primary Filtration 

Menu. The LED screen will display “PF.”

B.  Press the 

Warmer (   ) button to scroll through the Primary 

Filtration cycles. After the last cycle, “PF8,” the LED screen will 

display the number of days remaining or zero, Figure 3.

Note: If you press the Warmer (   ) button after the number of days 

remaining you will revert back to the “PF” menu. You will need to repeat 

step B to re-enter the menu.

C.  Press the 

Jets Pump 1 ( 

 ) button to access the Change Filter 

Timer. The display on the LED screen will blink once to indicate that 

the system is ready to accept changes.

D.  Pressing the 

Warmer (   ) or Cooler (   ) button will add or 

subtract days in increments of 10 days. The range is from 0 to 180 

days.

E.  Once you select the number of days, press the 

Jets Pump 1 ( 

 ) 

button to confirm the selection. The display of the LED screen will 

blink twice to indicate that the changes have been accepted. You 

must press the 

Jets Pump 1 ( 

 ) button to confirm your selection 

or the current settings will remain active.

F.  When the countdown timer reaches “0,” the LED 

display will flash between “CF” (Figure 4) and the water 

temperature. At this time the filters must be replaced or 

cleaned and the timer reset.

Note: If no button is pressed within 5 seconds of each selection the 

screen will revert back to the Main Menu and the current settings will 

remain active.

Figure 3

Figure 4