Jacuzzi J-345 Manuel D’Utilisation

33

To make changes to the CLEAR

RAY bulb replacement timer or to reset 

it, follow the steps below (Figure 7).

A.  Press the 

Menu ( 

 ) button three times to display the CLEAR

RAY 

Bulb Replacement Timer Menu. The LED screen will display “U.”

B.  Press the 

Warmer (   ) button to enter the menu. The LED screen 

will display the number of days remaining or zero.

Note: If you press the Warmer (   ) button after the number of days 

remaining you will revert back to the “U” menu. You will need to repeat 

step B to re-enter the menu.

C.  Press the 

Jets Pump 1 ( 

 ) button to access the CLEAR

RAY bulb 

replacement timer. The display on the LED screen will blink once to 

indicate that the system is ready to accept changes.

D.  Pressing the 

Warmer (   ) or Cooler (   ) button will add or 

subtract days in increments of 10 days except when 360 is reached. 

Then a 5-day increment occurs. The range for programming is from 0 

to 365 days.

E.  Once you select the number of days, press the 

Jets Pump 1 ( 

 )

button to confirm the selection. The display of the LED screen will 

blink twice to indicate that the changes have been accepted. You 

must press the 

Jets Pump 1 ( 

 ) button to confirm your selection 

or the current settings will remain active.

Note: If no button is pressed within 5 seconds of each selection the 

screen will revert back to the Main Menu and the current settings will 

remain active.

In Economy mode, the heater 

only activates after a Secondary Filtration 

cycle has finished. The heater will run for a maximum of 30 minutes. 

The heater can turn off prior to the 30 minutes if the programmed 

water temperature is reached. The Secondary Filtration program 

determines the number of cycles (from 1 to 4) that the heater will be 

allowed to activate. For example, if you have programmed the SF3 

setting (10 minutes of filtration every 6 hours), then the heater will run, 

for a maximum of 30 minutes, after the end of each of the 10-minute 

secondary filtration cycle, for up to four times per day. Reference the 

chart that follows.

Will return to 

the “U” menu

Blinks once

Blinks twice

Activates 

submenu for 

changes

Adds days in 

10-day incre-

ments

Substracts days 

in 10-day incre-

ments

Figure 7