Output Solutions ez-1000plus Mode D'Emploi

After pressing the FEED key, printer will send the media (according to media type) to the 
specified stop position. When printing with continuous media, pressing the FEED key will feed 
media out to a certain length. When printing labels, pressing the FEED key will feed one label at 
a time; if the label is not sent out in a correct position, please proceed with the Auto Sensing (see 
page 29). 
 
 

The Self-Test function in a printer will help user to figure out whether the printer is operating 
normally. In the Self-Test Mode, the printer will print out a test sample each time when the FEED 
key is pressed. To break off the Self-Test procedure, just turn off the printer. Below are the 
Self-Test procedures: 
 
1. 

Power off the printer, press and hold the FEED key. 

2. 

Power on the printer (while still holding the FEED key); release the FEED key after printer 
beeping 3 times. 

3. 

After about 1 second, printer would automatically print out the following. This indicates the 
printer is operating normally. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

EZXXXX : VX.XXX 
Serial port :96,N,8,1 
 
 
 
1 DRAM installed 
Image buffer size : 1500K 
000 FORM(S) IN    MEMORY 
000 GRAPHIC (S) IN MEMORY 
000 FONT(S)  IN  MEMORY 
000 ASIAN FONT(S) IN MEMORY 
000 DATABASE(S) IN MEMORY 
2048K BYTES FREE MEMORY 
^S4  ^H10  ^R000  ~R200 
^W10  ^Q48,3 
Option : ^D0  ^O0  ^AD 
See-through Sensor: OFF 
Reflective Sensor AD : 146    186    223 (2) 
Code Page:  850 
 

 

Model & Version 
Serial port setup 
 
Test pattern 
 
Number of DRAM installed 
Image buffer size 
Number of forms 
Number of graphics 
Number of fonts 
Number of Asian fonts 
Number of Databases 
Free memory size 
Speed, Density, Ref. Point, Print direction
Label width, Form length 
Cutter, Stripper, Mode 
See-through Sensor status 
Reflective Sensor status 
Code Page 

Self-Test includes the internal printer data setting. 
 
 
 

EZ-1000 Plus User’s Manual Rev. B 
 

28