Output Solutions ez-1000plus Mode D'Emploi

There are two types of sensor in EZ-1000 Plus printer - Reflective Sensor and See-through 
Sensor. Users can set one of them as active sensor. By default, the Reflective Sensor is turned 
on and the See-through Sensor is turned off. However, the reflective sensor may not be able to 
detect the label gap on special label materials. For example, when printing on labels with thick 
liner, colored liner, or back graphics, then the see-through sensor would need to be enabled 
since the reflective sensor may not work correctly.   
 
To turn the See-through Sensor on, please do as follows: 
 
1. 

Power off the printer, press and hold the FEED key. 

2. 

Power on the printer (while still holding the FEED key) and the printer will beep 3 times. 
Keep holding the FEED key, wait for the STATUS light turn red and READY light flash 
green, then release the FEED key. The printers will automatically print “SEE-THROUGH 
SENSOR IS ON”. This indicates that the See-Through Sensor is turned on (and the 
Reflective Sensor is turned off). 

3. 

To turn off the See-Through Sensor, please repeat above-mentioned procedures. Then the 
printer will print “SEE-THROUGH SENSOR IS OFF” to indicate that the See-Through 
Sensor is turned off.   

 
 
 
 
 
 
 
 

SEE-THROUGH SENSOR IS ON 
 
                            or 
 
SEE-THROUGH SENSOR IS OFF 

For checking the status of See-through Sensor (on or off), please perform Auto Sensing once. If 
both of READY and STATUS lights are green when doing Auto Sensing, then the See-through 
Sensor is on. If both of READY and STATUS lights are orange, then the See-through Sensor is 
off. 
 

【

】

EZ-1000 Plus User’s Manual Rev. B 
 

30