Agilent Technologies 8935 series e6380a Manuale Utente
Chapter 7
247
Configuration - Screens and Control Fields
Control Fields on the Configuration Screens
RF Offset
This field is displayed when the
RF Display
field is set to
Freq
.
This field enables/disables the RF generator
−
RF analyzer frequency
offset specified in the
(Gen)-(Anl)
field below it.
Operating Considerations
When an RF offset is used, changing the RF generator’s frequency or
RF analyzer’s tune frequency automatically alters the other setting.
RF analyzer’s tune frequency automatically alters the other setting.
See
for more
information.
Screen(s) Where Field is Present
INSTRUMENT CONFIGURE
Save/Recall
This field specifies which memory device the Test Set accesses when the
save and recall functions are used.
save and recall functions are used.
•
Internal
is a section of internal RAM. RAM is also used for running
IBASIC programs, which may require you to delete the save/recall
registers if the program is very large.
registers if the program is very large.
•
Card
is the front-panel MEMORY CARD (PC card) slot. A
Save/Recall Device is not Present
message is displayed if you
try to save or recall an instrument setup when a write-able PC card
is not installed in the Test Set.
is not installed in the Test Set.
•
RAM
refers to RAM disks that you can create on internal RAM. Refer
to the Programmer’s Guide for information on creating RAM disks.
This is part of the same memory used when “internal” is specified,
and may have to be erased when loading very large IBASIC
programs. A
This is part of the same memory used when “internal” is specified,
and may have to be erased when loading very large IBASIC
programs. A
Save/Recall Device is not initialized
message is
displayed if you try to save or recall an instrument setup when a
RAM disk has not been created.
RAM disk has not been created.
Screen(s) Where Field is Present
I/O CONFIGURE