Agilent Technologies E6380-90073 Manuale Utente
154
Chapter 1
GPIB Command Dictionary
CONFigure subsystem
:OFLevel:ANTenna <real number>
:OFLevel:ANTenna?
:OFLevel:ANTenna?
These commands set/query the path loss from the device-under-test to
the Test Set’s ANT IN port. This correction is applied when the
CONF:OFL:MODE ‘On’ command is used.
the Test Set’s ANT IN port. This correction is applied when the
CONF:OFL:MODE ‘On’ command is used.
This command utilizes the “Real Number Setting Syntax” on page 299,
but does not use the :STATe command.
but does not use the :STATe command.
Syntax
CONF:OFL:ANT <real number> !values:
−
100.0 to 100.0
CONF:OFL:ANT?
Screen/field equivalent
CONF:OFL:ANT controls the
Antenna In
field of the INSTRUMENT
CONFIGURE screen. This value in this field is used when the
RF
Level Offset
field is set to
On
.
:OFLevel:DUPLex <real number>
:OFLevel:DUPLex?
:OFLevel:DUPLex?
These commands set/query the path loss from the DUPLEX OUT
connector to the device-under-test. This correction is applied when the
CONF:OFL:MODE ‘On’ command is used.
connector to the device-under-test. This correction is applied when the
CONF:OFL:MODE ‘On’ command is used.
This command utilizes the “Real Number Setting Syntax” on page 299,
but does not use the :STATe command.
but does not use the :STATe command.
Syntax
CONF:OFL:DUPL <real number> !values:
−
100.0 to 100.0
CONF:OFL:DUPL?
Screen/field equivalent
CONF:OFL:DUPL controls the
Duplex Out
field on the INSTRUMENT
CONFIGURE screen. This value in this field is used when the
RF
Level Offset
field is set to
On
.