Agilent Technologies E6380-90073 Manuale Utente
![Agilent Technologies](https://files.manualsbrain.com/attachments/f20ae6efbee7636e6d0d1a481fd9e3847e3caeb5/common/fit/150/50/991587f279eee8cef3aa0a068e5c2f53d86b00e1bf17fbcbf9a87aa49d96/brand_logo.png)
Chapter 1
155
GPIB Command Dictionary
CONFigure subsystem
:OFLevel:RFINout <real number>
:OFLevel:RFINout?
:OFLevel:RFINout?
These commands set/query the path loss from the RF IN/OUT
connector to the device-under-test. This correction is applied when the
CONF:OFL:MODE ‘On’ command is used.
connector to the device-under-test. This correction is applied when the
CONF:OFL:MODE ‘On’ command is used.
This command utilizes the “Real Number Setting Syntax” on page 299,
but does not use the :STATe command.
but does not use the :STATe command.
Syntax
CONF:OFL:RFIN <real number> !values: minus 100.0 to 100.0
CONF:OFL:RFIN?
Screen/field equivalent
CONF:OFL:RFIN controls the
RF In/Out
field of the INSTRUMENT
CONFIGURE screen. This value in this field is used when the
RF
Level Offset
field is set to
On
.
:OFRequency <real number>
:OFRequency?
:OFRequency?
These commands set/query the frequency offset between the Test Set’s
generator and analyzer. This command is used only in frequency tuning
mode (CONF:RFD ‘Freq’) and RF offset must be turned on
(CONF:OMODE ‘On’).
generator and analyzer. This command is used only in frequency tuning
mode (CONF:RFD ‘Freq’) and RF offset must be turned on
(CONF:OMODE ‘On’).
This command utilizes the “Real Number Setting Syntax” on page 299,
but does not use the :STATe command.
but does not use the :STATe command.
Syntax
CONF:OFR <real number>
CONF:OFR?
Screen/field equivalent
CONF:OFR controls the
(Gen)-(Anl)
field of the INSTRUMENT
CONFIGURE screen.