Agilent Technologies E6380-90073 Manuale Utente
196
Chapter 1
GPIB Command Dictionary
DECoder subsystem
:LEVel:FM <real number>
:LEVel:FM?
:LEVel:FM?
These commands set/query the expected data signal level (after
de-emphasis, if used). For more information about the effects of
de-emphasis, see the “De-emphasis and Input Level” in the Reference
Guide.
de-emphasis, if used). For more information about the effects of
de-emphasis, see the “De-emphasis and Input Level” in the Reference
Guide.
The higher the level of signal expected by the analyzer, the higher the
trigger level is set.The input level should be set high enough to prevent
false triggering, but low enough to allow triggering for valid signals.
This may require you to set the input level well below the expected level.
trigger level is set.The input level should be set high enough to prevent
false triggering, but low enough to allow triggering for valid signals.
This may require you to set the input level well below the expected level.
This command requires one of the following settings for the AF
analyzer’s input (AFAN:INP), ‘FM Mod’ or ‘FM Demod’.
analyzer’s input (AFAN:INP), ‘FM Mod’ or ‘FM Demod’.
This command utilizes the “Real Number Setting Syntax” on page 299,
but does not use the :STATe command.
but does not use the :STATe command.
Syntax
DEC:LEV:FM <real number>
DEC:LEV:FM?
Screen/field equivalent
DEC:LEV:FM controls the
Input Level
field on the SIGNALING
DECODER screen when the
AF Anl In
field is set to
FM Mod
or
FM
Demod
.