Agilent Technologies E6380-90073 Manuale Utente
Chapter 1
93
GPIB Command Dictionary
AFG2|ENCoder subsystem
:NAMPs|NTACs[:FOCC]:RATE <real number>
:NAMPs|NTACs[:FOCC]:RATE?
:NAMPs|NTACs[:FOCC]:RATE?
These commands set/query the data rate of the encoded message.
This command utilizes the “Real Number Setting Syntax” on page 299
but does not use the :STATe command.
but does not use the :STATe command.
Syntax
AFG2:NAMP:FOCC:RATE
AFG2:NAMP:FOCC:RATE?
Screen/field equivalent
AFG2:NAMP[:FOCC]:RATE controls the
Data Rate
field on the
SIGNALING ENCODER screen when the
Mode
field is set to
NAMP-NTAC
, and the
Channel
field is set to
Cntl
.
:NAMPs|NTACs[:FOCC]:FILLer:DATA1 <string>
:NAMPs|NTACs[:FOCC]:FILLer:DATA2 <string>
:NAMPs|NTACs[:FOCC]:FILLer:DATA1?
:NAMPs|NTACs[:FOCC]:FILLer:DATA2?
:NAMPs|NTACs[:FOCC]:FILLer:DATA2 <string>
:NAMPs|NTACs[:FOCC]:FILLer:DATA1?
:NAMPs|NTACs[:FOCC]:FILLer:DATA2?
These commands set/query FOCC filler data. Each filler contains 7
hexadecimal characters representing the 2 type bits and 26 information
bits of the control filler/message word. The control filler is sent
continuously when the :NAMPs|NTACs[:FOCC]:FILL:SEND command
is used or after a control message has been sent using
:NAMPs|NTACs:SEND.
hexadecimal characters representing the 2 type bits and 26 information
bits of the control filler/message word. The control filler is sent
continuously when the :NAMPs|NTACs[:FOCC]:FILL:SEND command
is used or after a control message has been sent using
:NAMPs|NTACs:SEND.
Both filler fields must be full (seven digits) for the forward control
channel information to be structured correctly. Do not leave any blank
spaces.
channel information to be structured correctly. Do not leave any blank
spaces.
To use this command, AFG2:NAMP:CHAN must be set to ‘Cntl’.
Syntax
AFG2:NAMP[:FOCC]:FILL:DATA1 <string>
AFG2:NAMP[:FOCC]:FILL:DATA2 <string>
AFG2:NAMP[:FOCC]:FILL:DATA1?
AFG2:NAMP[:FOCC]:FILL:DATA2?
Screen/field equivalent
AFG2:NAMP[:FOCC]:FILL:DATA1 and DATA 2 control the
Filler
fields for Stream A and Stream B on the SIGNALING ENCODER
screen when the
screen when the
Mode
field is set to
NAMP-NTAC
, and the
Channel
field is
set to
Cntl
.