Ironman Fitness V2 Manuale Utente
47
The Remote Control
The batteries in the remote control will need to be replaced once every
1 to 3 years, depending on usage. You are able to recognise when the
batteries are low by the remote control range reducing. Below
describes how to replace the batteries in the remote control.
Battery Specifications
Battery Type
2 x Lithium button cells
Model
CR1616
Voltage
3 Volts
The Wireless PIR Detector
Replacing the Batteries
The batteries can be removed by:
1. Depressing the battery retention clip by pushing it in the
direction indicated by the arrow in the image to the right.
2. The new batteries must be handled only by the edges as
leaving fingerprints can cause a poor battery connection
over time.
3. Fingerprints can be cleaned off the batteries with a soft
cloth and some alcohol solution.
4. The new batteries can now be placed, bottom edge first,
into the battery holder and then pushed down till they clip
into place.
5. Just after each battery is replaced the lights will begin
flashing 6 times to confirm the detector is now powered.
6. The warm up period now applies (see section 2.5.3).
Wireless PIR Detector Battery Specifications
Battery Type
2 x Lithium button cells
Model
CR2450
Voltage
3 Volts
When replacing the batteries you must take the following into consideration:
You must replace both batteries at the same time. Don’t just replace one of them.
Be sure not to touch the pyro detector on the removal or replacement of the batteries.
Carry out a walk test to ensure the detector is operating correctly.