Lexmark 4097-00X Manuale Utente

Service Manual

1. Remove the front cover.

2. Remove the carrier frame.

3. Disconnect the carrier transport motor connector from the 

system board.

4. Remove the belt from the carrier transport motor pulley.

5. Unlatch the right side of the sheet feeder and unhook the carrier 

transport motor cable.

6. Remove the two screws securing the carrier transport motor to 

the carrier frame and remove the motor. Note the routing of the 
motor cable.

1. Remove the front cover.

2. Unlatch and remove the exit roller bushing from the left side of 

the gear plate. Note of the position of the spring located on the 
end of the exit roller shaft.

3. Remove the spring and lift the exit roller out of the machine.

1. Remove the two cover mounting screws from the upper rear 

corners of the of the rear cover. When reassembling, do not 
overtighten these screws as they will damage the plastic 
threads. 

2. Lift up on the two cover latches located on each side of the base 

cover.

3. Pull the front cover forward and remove. 

1. Remove the front cover.

2. Remove the carrier frame.

3. Remove the large feed roller.

4. Disconnect the paper feed motor and the power connector from 

the system board. Note the routing of all cables.

5. Remove the two gear plate assembly screws from the carrier 

frame and remove the gear plate.