Xerox 4118 Guida Utente

Use these instructions to install the device on a TCP/IP network using CentreWare Internet 
Services.

There are two stages required to install the device on a TCP/IP network using CentreWare 
Internet Services:

¾

Configure the WorkCentre 4118

This procedure explains how to use CentreWare Internet Services to 
configure the device.

¾

Test Print

A print job should be submitted to ensure the device has been installed and 
configured correctly.

NOTE: The TCP/IP settings for the device will have been setup when completing 
the Enabling CentreWare Internet Services section.

To complete the installation of the device, perform these steps:

¾

Enable CentreWare Internet Services (see “Enabling Internet Services” on page 7-5).

¾

At the CentreWare Internet Services Home Page for the WorkCentre 4118, select the 
[Properties] tab.

¾

Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and 
then select the [+] symbol to the left of the Protocols folder. 

¾

Select [TCP/IP] and check the Protocol Configuration details are correct. If any of the 
details are incorrect then enter the correct information.

¾

In the Physical Connection field, Ethernet will be the default setting.

Select the checkbox to enable TCP/IP.

Enter the [Host Name].

Choose the [IP Address Resolution] required.