LG 37LD650H Manuale Utente

206-4137

Installer Menu

Installer Menu item settings

Channel

Auto Tuning (Channel Lineup)

Channel Edit

Channel Label

Picture

Aspect Ratio

Picture Mode

Advanced Control

Audio

Auto Volume

Clear Voice

Sound Mode

Balance

TV Speaker

Option

Menu Language

Audio Language

Caption

Caption Mode

Digital Caption Options

Lock

Movie Rating

TV Rating – Children

TV Rating – General

Input Block

Time

Auto Clock

Manual Clock

Off Time

On Time

Auto Off (Sleep Timer)

Cloning Overview / Clonable Menu Features

Note: Menu options vary between analog and digital channels and Aux sources.

Clonable Menu Features

IMPORTANT CLONING INFORMATION

There are three options for cloning a Master TV Setup:
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each option is described in further detail on the pages that

follow. As you perform cloning procedures, be sure to com-

plete each task as indicated. If a procedure or step is omit-

ted or not performed completely, cloning may not work. At

each step, pay attention to ensure the TV screen shows

the proper message when cloning. If the message indicat-

ed does not appear, there is a problem with that step, and

cloning may not be successful.

Warning: Copying a blank or incorrect memory

into a TV, STB, or other device will cause the TV,

STB, or other device to operate erratically or

become inoperable.
Warning: Do not connect a clone programmer to

any PPV card installed in the Master TV or any

MPI port while the TV is in PPV Mode, or the

clone programmer and the PPV card will be

damaged.

Before you begin cloning:
• Complete the Commercial Mode Setup procedure on

pages 13 to 14.

• The Master TV EBL must be in Pass-through Mode.
• Ensure the Master TV is connected to a good, stable

signal source, the TV source selected is Antenna (RF)

In, and the signal is from an Aux source or analog (not a

digital) channel.

• All equipment should be connected to power and turned

ON.

• Learning and Teaching is only possible between identical

model TV/STBs.

• Make sure the batteries in the clone programmer, if ap-

plicable, are fresh. If batteries are removed, the Clone

Clock Time will be lost.

• If using a USB memory device, ensure the memory de-

vice has been formatted with FAT format.

• If using a clone programmer, decide if you want to set the

time from the clone programmer or copy the time to the

clone programmer from a compatible TV which has the

clock set to the current time.