ATTO Technology FC-84EN ユーザーズマニュアル

  

3

Power on the target system while pressing and 
holding ‘T’, this will boot the target system in 
target disk mode. You may release the key 
when the FireWire symbol appears.

4

On the host system, insert the OS X installation 
disc and begin installation. Proceed through the 
installation wizard until you reach the 
destination volume selection window. 

5

Select a volume on the storage attached to the 
Celerity adapter. If a volume is not present, 
open the Disk Utility from the OS X Installer 
menu to create a volume. The storage will 
appear in Disk Utility as ‘AAPL FireWire Media’. 
Exit the Disk Utility when finished and select the 
newly created volume. 

6

Finish the OS X installation, restart the host 
system when prompted, and complete the OS 
X setup wizard. You may now remove the OS X 
installation disc. 

7

8

On the host system, open System Preferences 
and restore the Startup Disk to the disk that the 
host system booted from before performing this 
procedure. After restarting, you may disconnect 
the FireWire cable from the target system. The 
host system is no longer needed. 

9

Power off the target system and power it back 
on again normally. If you previously had an OS 
X installation present, it will boot that version of 
OS X. Otherwise, the new OS X installation will 
be booted. 

10 On the target system, open System 

Preferences and set the Startup Disk to the new 
OS X installation and restart. 

Note

1

Power on your system and log in as the 
administrator or a user with proper 
administrative privileges.

2

Insert the Installation CD.

3

After the CD mounts, open the Celerity volume 
on the desktop.

4

Open the Linux folder.

5

Open the Drivers folder.

6

Open the folder corresponding to the speed of 
the HBA.

7

Copy the .tgz file to a temporary folder.

8

Open a terminal window and change to the 
location of copied tgz from step 7.

9

Extract the file using the command tar -xfz 
<filename.tgz>.

10 Change to the directory created above then run 

the installer script ./install.sh.

Note

For ESX Server 3.5 please refer to 

During ESX 4.x installation, you may choose to install 
customer drivers. This will allow you to install ESX to 
storage that is attached to your ATTO adapter.
1

During ESX installation, select Yes to install 
customer drivers and click Add.

2

The installer will prompt you to insert the media 
containing the ATTO device driver.

3

After you add the ATTO driver, the installer will 
prompt you to reinsert the ESX installation 
media and continue with the installation.

1

Extract the Driver CD ISO on your local 
workstation using an third party ISO reader.

Note