Enterasys Networks 2G4082-25 ユーザーズマニュアル
Matrix DFE-Platinum Series Hardware Installation Guide B-1
B
Mode Switch Bank Settings
and Optional Installations
This appendix covers the following items:
Required Tools
Use the following tools to perform the procedures provided in this appendix:
•
Antistatic wrist strap
•
Phillips screwdriver
Setting the Mode Switches
shows the location of the mode switches and the switch settings for normal operation.
These switches are set at the factory to the off position and rarely need to be changed.
Switch definitions and positions are as follows:
•
Switches 1 through 6 – For Enterasys Networks use only.
•
Switch 7 – Clear Persistent Data. Changing the position of this switch clears Persistent Data on
the next power‐up of the module. All user‐entered parameters, such as the IP address or
module names, are reset to the factory default settings. Once the module resets, you can either
use the factory default settings or reenter your own parameters.
the next power‐up of the module. All user‐entered parameters, such as the IP address or
module names, are reset to the factory default settings. Once the module resets, you can either
use the factory default settings or reenter your own parameters.
For information about...
Refer to page...
Caution: An antistatic wrist strap is required to perform the following procedures to minimize ESD
damage to the devices involved.
damage to the devices involved.
Precaución: Para minimizar los efectos de las descargas de electricidad estática, deberá utilizar
una pulsera antiestática al realizar los siguiente procedimientos.
una pulsera antiestática al realizar los siguiente procedimientos.
Caution: Read the appropriate sections to be fully aware of the consequences when changing
switch settings.
switch settings.
Only qualified personnel should change switch settings.
Precaución: Si desea modificar la configuración del interruptor, lea las secciones
correspondientes para saber cuál será el resultado de hacerlo.
Estas modificaciones a la configuración sólo debe realizarlas personal calificado.
correspondientes para saber cuál será el resultado de hacerlo.
Estas modificaciones a la configuración sólo debe realizarlas personal calificado.