avolites pearl exper ttitan ユーザーズマニュアル
Copyright Avolites Limited 2010
Page 48 – 3. Controlling dimmers and fixtures
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
You can also recall a group by its number:
1> Press the grey Group button.
2> Type in the number of the group you want to recall.
3> Press [Recall Group].
2> Type in the number of the group you want to recall.
3> Press [Recall Group].
•
The Group button also gives you facilities on the softkeys to edit
and delete groups.
3.1.11 Stepping through selected fixtures one at a time
If you have selected a range of fixtures, or a group, the Pearl has
functions to step through the selected fixtures one at a time. This can
make it easier to program a range of fixtures because you don’t have
to select each one manually.
This mode uses the Prev/Next/All/Hilight buttons to the right of the
This mode uses the Prev/Next/All/Hilight buttons to the right of the
Go button.
1> Select a range of fixtures or a group.
2> The Prev and Next buttons will select the fixtures in the range
2> The Prev and Next buttons will select the fixtures in the range
one at a time (in the order you selected them).
3> The ALL button will select all fixtures in the programmer
(everything which has been selected since Clear was last
pressed).
•
The Hilight function can be used to highlight the output of the
selected fixture (make it brighter onstage), see the next
section.
3.1.12 Highlighting the selected fixture
When stepping through a fixture selection using the Prev/Next/All
buttons, you can highlight the selected fixture on stage. This makes it
very easy to see which fixture you are controlling. The other fixtures in
the selection go to a dimmed level.
Press the HiLight button to enable highlight mode. Press HiLight again
Press the HiLight button to enable highlight mode. Press HiLight again
to disable hilight mode. When you are in hilight mode, the hilighted
attribute is overridden and any changes you make to it are not stored in
the programmer (so if the hilight uses intensity, you cannot change the
intensity of the fixture).
3.1.13 Align fixtures
You can copy attributes from one fixture to another using the Align
Fixtures function. This is very useful, for example, if you’ve
accidentally left a fixture out of a cue you can copy settings from its
neighbour.
1> Select the fixtures you want to Align.
2> Press ML Menu then [Align Fixtures].
3> Set the mask to include the attribute groups you want to copy
2> Press ML Menu then [Align Fixtures].
3> Set the mask to include the attribute groups you want to copy
(using the Attribute Bank buttons on the right of the console,.or
the softkeys set options for exclude and include all attributes).
4> Press the handle of the fixture you want to copy the settings
from.