TP-LINK TL-SG3210 사용자 설명서
115
Parameter
rate —— Select the bandwidth for receiving multicast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the multicast control function for port 5:
TL-SG3424(config)# interface gigabitEthernet 1/0/5
TL-SG3424(config-if)# storm-control multicast
storm-control unicast
Description
The storm-control unicast command is used to enable the unicast control
function. To disable the unicast control function, please use no storm-control
unicast command. Unicast control function allows the switch to filter UL frame
in the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control unicast [ rate rate ]
no storm-control unicast
Parameter
rate —— Select the bandwidth for receiving UL-Frame on the port. The packet
traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the unicast control function for port 5:
TL-SG3424(config)# interface gigabitEthernet 1/0/5
TL-SG3424(config-if)# storm-control unicast