SEAL AQUA AS-1600 사용자 설명서

 

 
 

12 

All Pre-heat control operations are controlled from the Control Panel as shown in 
Figure 2.2 

1.  Switch machine to START at the Main Power Switch 

• 

Laminator will power-up  

• 

Dryer Panel is in the UP position. 

• 

Heaters are OFF. 

 

 

2.  On the Heater Controller, press and hold the  SET  button to check the set-point 

temperature.  Adjust the set point by holding the SET button down and using the 
UP/DOWN arrows to scroll to the desired temperature setting. 

Note:  Most vinyl’s run well with a SET POINT temperature of 315°C (600°F) 

3.  Press the Heater Switch to ON to power the Dryer Panel and begin heating.  

4.  Once the machine reaches its SET POINT it is ready to be operated.