Elica EFG630SM 설치 설명서

Description of the hood & Control

Blower and light controls

Lamp housings

Grease filter Handle

Grease Filter

Canopy

Duct covers

Controls

Use the high suction speed in case of concentrated kitchen

vapours. It is recommended that the cooker hood suction is

switched on for 5 minutes prior to cooking and to leave in op-

eration during cooking and for another 15 minutes approxi-

mately after terminating cooking.

Note: Hood retains last speed setting when aspiration switch

is turned off.

Description of control panel

1. Light Button

Press lamp button to turn ON the light on High
Intensity (Lamp state previously OFF).
Press lamp button to turn ON the light on Low
Intensity (Lamp state previously ON).
Press lamp button to turn OFF the light (Lamp
state previously ON).

•

2. Timer Button

The default timer setting is 10 minutes, and

it can be adjusted between 60 minutes and 1

minute.

After pressing the timer button, the control en-

ters to a timer setup mode, and user can adjust

the timer countdown time with the “+” and “-”

buttons within 5 seconds. The timer can be initi-

ated immediately pressing the timer button. after

setting the timer duration or pressing the timer

button twicw ( default 10 minutes setting).

If no action occurs within 5 seconds, the count-

down will start.

During the timer setup the “+” and “-” buttons

are dedicated to the timer and no motor action

will occur.

Once the timer is initiated, it can be cancelled
by pressing the timer button again.

3. Display

Shows the hood settings.

The display will be lit at low intensity when the

hood is not operating.

Pressing and key the display will light up at

high intensity.

The display will be lit at high intensity when the

hood is operating.

If no key is pressed within a minute the display

will return to being at low intensity.

4. “-” Button. Speed Decrease / OFF

This button is used to decrease the fan speed,

or turn OFF the fan.

The fan will turn OFF if the “-” button is pressed

and the hood was in the first speed.

If the fan is at second speed and the “-” button

is pressed, the fan will be set to first speed.

If the fan is at third speed and the “-” key is

pressed, the fan will be set to second speed.

If the fan is at fourth speed and the “-” button is

pressed, tha fan will be set third speed.

If the fan is OFF and the “-” button is pressed,

the control backlight will light up.

5. “+” Button. Speed Increase / ON

This button is used to increase the fan speed,

or turn ON the fan.

The fan will turn On if the “+”button is press and

the hood was OFF.

If the fan is at first speed and the “+” button is

pressed, the fan will be set to second speed.

If the fan is at second speed and the “+” button

is pressed, the fan will be set to third speed.

If the fan is att third speed and the “+” button is

pressed, the fan will be set to fourth speed.

If the fan is at fourth speed and the “+” button is

pressed, a beep will sound.

•