Avalon Stoves DVL Insert EF II Manual Do Utilizador

© Travis Industries

100-01174_002

The  blower  helps  transfer  heat  from  the  heater  into  the  room.    It  will  not  turn  on  until  the  heater  is
up  to  temperature  (approximately  10  minutes  after  starting).    See  the  illustration  below  for
instructions  on  adjusting  the  blower  speed.

Turn the dial all the 
way counter-clockwise 
until it clicks off.

The high position is all the 
way counter-clockwise, 
without clicking off.

Turn the dial all the 
way clockwise.

Gas Control Valve
As the gas control valve is turned on 
and off you will hear a dull clicking 
sound.  This is the valve opening up 
and shutting down.

Blower Snap Disk 
This part can produce a clicking 
sound  as it turns the blower on 
and off.

The appliance will creak 
with change of temperature.

Pilot Flame
The pilot flame, 
which remains on, 
makes a very slight 
"whisper" sound.

Blower 
This heater uses a blower to push heated air 
into the room.  You will hear the sound of air 
movement that increases as the speed is 
increased.

Extinction Pops 
It is not unusual, especially on 
Propane (LP) appliances, to 
experience a "pop" when the 
burner is shut off.

This  appliance  has  several  areas  that  reach  high  temperatures.    Dust  or  other  particles  on  these
areas  may  burn  and  create  an  odor.    This  is  normal  during  start-up.    You  may  notice  the  smell  is
more  acute  if  the  appliance  was  left  idle  for  a  long  period.