LG BD430 Manual Do Proprietário

55

When the service life of the projection lamp is 

over, the icon suggests that the lamp needed to 

be replaced will appear on the screen, and the 

LAMP indicator on the top control will lights red. In 

this case, you should immediately replace it with 

a new one of the same model. The lighting time of 

the LAMP indicator is subject to the lamp mode.

1. Power off the projector and unplug the power

    cord. Then let the project cool for at least 45

    minutes.

2. Loosen the screws on the lamp cover and open

    the cover.

3. Loosen the two screws that secure the lamp. Lift

   the lamp out of the projector by using the handle.

4. Replace the lamp with a new one and secure

    the two screws.

    Make sure that the lamp is set properly. Close

    the lamp cover and secure the screw.

5. Plug the AC power cord and power on the

    projector.

As temperature inside the projector is high, 

you should cool the projector for at least 45 

minutes before you open the lamp cover.

When the lamp isn’t illuminated, it may indicate that the lamp has been damaged.

When you replace the lamp in a projector installed on the ceiling, you should stand beside 

the lamp cover but not under it; for the broken glass may fall down to hurt you. To do that, 

remove the lamp cover gently to avoid being hurt by the dropped glass. If glass drops into 

your eyes or mouth, you should see the doctor immediately.

For the sake of safety, only use the lamp of 

the same model. Never drop the lamp onto the 

ground nor touch the glass bulb! The glass can 

shatter and hurt.

Lamp cover

Screw

Handle

Screw

Screw

Lamp

AUTO

INPUT

OK

/

MENU

Top Control

LAMP REPLACE 

indicator lights 

red.

Lamp replacement icon

Replace the lamp