TP-LINK TL-MR3420 Manual Do Utilizador

 



 

Broadband Internet Access Service (DSL/Cable/Ethernet) 



 

One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router 

is connected directly to the Ethernet.) 



 

PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors   



 

TCP/IP protocol on each PC 



 

Web browser, such as Microsoft Internet Explorer 5.0 , Netscape Navigator 6.0 or above 



 

Place the Router in a well ventilated place far from any heater or heating vent   



 

Avoid direct irradiation of any strong light (such as sunlight) 



 

Keep at least 2 inches (5 cm) of clear space around the Router 



 

Operating Temperature: 0 ~40  (32 ~104 )

℃

℃

℃

℃

 



 

Operating Humidity: 10%~90%RH, Non-condensing 

Before installing the Router, make sure your PC is connected to the Internet through the 

broadband service successfully. If there is any problem, please contact your ISP. After that, 

please install the Router according to the following steps. Don't forget to pull out the power plug 

and keep your hands dry. 

1.  Power off your Cable/DSL Modem, and the Router.   

2.  Locate an optimum location for the Router. The best place is usually at the center of your 

wireless network. The place must accord with the 

3.  Adjust the direction of the antenna. Normally, upright is a good direction. 

4.  Connect the PC(s) or Switch/Hub in your LAN to the LAN Ports of the 3G/4G Router with 

Ethernet cable.   

5.  The 3G/4G Router supports both 3G/4G and WAN connection; so you can insert 3G/4G 

USB Modem to the USB port of the Router (as shown in Figure 2-1), or connect the 

DSL/Cable Modem to the WAN port of the Router (as shown in Figure 2-2). Please visit our 

website  http://www.tp-link.com to get the latest USB modems compatibility, and we 

recommend you to check whether the modem in your hand has already been tested by us. 

6.  Connect the power adapter to the power socket on the Router, and the other end into an 

electrical outlet. The Router will start to work automatically. 

7.  Power on your Cable/DSL Modem. 

-5-