Справочник Пользователя для Hunter Fan Type T Models

42747-01 • 09/21/07 • Hunter Fan Company

2-1.  Drill two pilot holes into the wood support structure through the 

outermost holes in the outlet box. The pilot holes should be 9/64”
in diameter.

2-2.  Your fan comes with four neoprene noise isolators (“Isolators”). 

Position the isolators between the ceiling plate and ceiling by 
inserting the raised areas on each isolator into the holes in the 
ceiling plate.

2-3.  Thread the lead wires from the outlet box down through the hole 

in the middle of the ceiling plate.

2-4.  Align the slotted holes in the ceiling plate with the pilot holes you

drilled in the wood support structure. For proper alignment use 
slotted holes directly across from each other. 

    Note: The isolators should be flush against the ceiling.
2-5.  Place a flat washer on each of the two 3” screws and pass the 

screws through the slotted holes in the ceiling plate into the pilot 
holes you drilled. 

   Tighten the screws into the 9/64” pilot holes; do not use lubricants

on the screws. Do not over tighten.

Flat Washer

3” Screw

For Angled Ceilings: Be sure to 
orient the ceiling plate so that the 
arrows printed on the ceiling plate are 
pointing toward the ceiling peak. 

Ceiling

 Plate

Isolator