Справочник Пользователя для Hunter Fan Type T Models

42747-01 • 09/21/07 • Hunter Fan Company

You can assemble your fan for standard mounting (steps 3-1 – 3-2) 
or for low profile mounting (steps 3-3 – 3-4). Note: For low profile 
mounting, the downrod is replaced with the low profile washer.  
3-1.  To assemble fan to hang down from a flat or angled ceiling, insert 

the downrod through the canopy and canopy trim ring. Feed the 
wires from the fan through the downrod.

3-2.  Loosen the allen head set screw on the adapter using the large 

allen wrench. Screw the pipe and ball assembly into the fan 
assembly. Note: When the pipe and ball assembly is fully installed, 
2-3 threads on the pipe will still be visible; this is normal. Securely
retighten the set screw with a wrench or pliers. Skip to Step 3-5.

     

 CAUTION: The adapter has a special coating on the threads. Do 

not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.

3-3.  Place the low profile washer (lip up) into the canopy. Be sure the 

green ground wire is pointing up toward the ceiling.

3-4. Align the holes in the washer with the holes in the adapter.

Assemble securely with three #8-32 x 3/4” screws.

3-5. Raise the fan and place the hook on the ceiling plate through the

U-shaped hole in the rim.

     

 WARNING:  Fan may fall if not assembled as directed in these 

installation instructions.

#8-32 x 3/4” Screw

Low Profile Washer

Downrod 

Canopy

Canopy 

Trim Ring

Set Screw

U-shaped

Hole