Справочник Пользователя для Ingersoll-Rand 4581740

24 

04581740_ed2

The Host Address is only used when Host Data Out has been selected in the Protocol parameter.

For more information on applying the Serial Setup screen to particular devises, see section 2.4.1 Printer Connections 

When a PC is connected to the Insight controller via the Ethernet, the Setup menu’s Ethernet Setup sub-menu screen 

must be correctly programmed to allow the Insight controller to communicate with the PC. 

1.  When you select Ethernet Setup from the Setup menu, the screen shows the present Ethernet settings.

Figure 20 - Ethernet Setup, Present Settings

2.  To make changes to the present settings, press the Enter key to access the screen that allows data entry of the 

Ethernet parameters.

Figure 21 - Ethernet Setup, Change Settings

3.  Once on the data entry screen, make any necessary changes to the IP Address, Subnet, Gateway, Sys Port #, ICS 

Port #, and NTP Address. You can also turn Dynamic Host Communications Protocol (DHCP) On or Off on this 

screen. When DHCP is turned On, it allows the network server to set IP addresses for this unit.

NOTE: Sys Port # sets the port number used to send the EOR data if requested on Ethernet. ICS Port # sets the port 

number used to send and receive data to and from the ICS software. In most cases this should be left to the default 

value of 50001.

 

NOTE: Ethernet changes do not go into effect until the controller is rebooted.

Remember that the Job Number and CAN Address on the System Setup screen must be correctly set to allow a PC to 

communicate with the Insight controller. See Section 3.3.3 Job Number and CAN Address for details on how to make 

changes to those parameters.