Справочник Пользователя для hussman IGFP-R3

Rev. 0608

non-glare glass

Windex

or Glass Plus

are the only solutions recommended

to be used to clean the non-glare glass. The damage to the

glass from improper, caustic solutions is irreparable.
In addition to cleaning the glass with the recommended

product, there are precautions that should be taken when

working and cleaning the inside of the case.

• When cleaning the inside of the cases, we

recommend that the glass be fully opened and

covered to prevent to prevent solutions from

splashing onto the glass and ruining the coating on

the inside.

Plexiglass and acrylic care

Improper cleaning not only accelerates the cleaning cycle

but also degrades the quality of this surface. Normal daily

buffing motions can generated static cling attracting dust

to the surface. Incorrect cleaning agents or cleaning cloths

can cause micro scratching of the surface, causing the

plastic to haze over time.
cleaning

Hussmann recommends using a clean damp chamois, or a

paper towel marketed as dust and abrasive free with

210

Plastic cleaner and Polish available by calling Sumner

Labs at

1-800-542-8656. Hard, rough cloths or paper towels

will scratch the acrylic and should not be used.
antistatic coatings

The

210

has proven to be very effective in not only

cleaning and polishing the Plexiglass surface, but also

providing antistatic and anti-fog capabilities. This product

also seals pores and provides a protective coating.

User information (cont'd)

CLEANING PRECAUTIONS

When cleaning:

• Do not use high pressure water hoses

• Do not introduce water faster than waste outlet can drain

• NEVER ON A SELF CONTAINED UNIT WITH AN EVAPORATOR FAN

• NEVER USE A CLEANING OR SANITIZING SOLUTION THAT HAS AN OIL

BASE (these will dissolve the butyl sealants) or an AMMONIA BASE

(this will corrode the copper componets of the case)

TO PRESERVE THE ATTRACTIVE FINISH:

• DO USE WATER AND A MILD DETERGENT FOR THE EXTERIOR ONLY

• DO NOT USE ABRASIVES OR STEEL WOOL SCOURING PADS

(these will mar the finish)

evaporator fans

The evaporator fans are located at the center front of these

merchandisers directly beneath the display pans. Should

fans or blades need servicing, always replace fan blades

with the raised embossed side of the blade TOWARD THE

MOTOR.
copper coils

The copper coils used in Hussmann merchandisers may

be repaired in the field. Materials are available from local

refrigeration wholesalers.
Hussmann recommends using #15 Sil-Fos for repairs.
tips and troubleshooting

Before calling for service, check the following:

1. Check electrical power supply to the equipment for

connection.

2. Check fixture loading. Overstocking case will affect

its proper operation.

3. If frost is collecting on fixture and/or product,

check that no outside doors or windows are

open - allowing moisture to enter store. These

merchandisers were designed for use in stores were

temperature & humidity does not exceed 75° F and

55% H.