Справочник Пользователя для Omni Group GREEN SMART 864

Finalizing the Installation

(for qualified installers only)

4090507

100-01217_000

Steps for Finalizing the Installation

1. Remove the glass (see page 40).

NOTE:

If using propane (LP) convert the appliance prior to installing the logs.

2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected

once it enters the firebox, ensuring gas does not build up.
NOTE:

If using firebacks, install them prior to adjusting the accent light deflectors.

3. Carefully bend the accent light deflectors outwards to 45* (see “a” below). Take care to prevent damage to the

bulbs. Make sure the two accent light bulbs are in place. The assembly may be removed for bulb replacement
(see “b” below).
NOTE: .Take care to not touch the bulb with your fingers (use a cloth or paper towel).

4. Install the four AA batteries (included in the owner’s pack) into battery holder (see the illustration below). The AA

batteries act as a power backup in case the household (AC) power goes out. Install the 9v battery (included in
the owner’s pack) into control panel light assembly (see the illustration below). The battery holder is held in place
with Velcro and may be removed for easier access.

AA Battery

Lift up and swing the lower
grill down to acces the area
below the firebox.

Swing the concealment
cover up and slide it back to
expose the controls.

AA
Battery
Holder

AA Battery Tray

AA Battery

Battery

Battery Holder for
Control Panel Lights