Справочник Пользователя для Omni Group GREEN SMART 864

© Travis Industries 

4090507 

100-01217_000 

5.  Install the logs (see page 42). 
6.  Replace the glass. 
7.  Start the heater.   
8.  Leak test all gas joints.   
9.  Check the air shutter following the directions below. 

Let the heater burn for fifteen minutes (make sure the logs and glass are in place).  The flames should be 
yellow with no sooting.  Adjust the air shutter, if necessary, to achieve the correct looking flame. 

Correct

Flames should be blue at the 
base, yellow-orange on the top.

If the flames are too tall or sooty on the 
ends, open the air shutter.

Not Enough Air

If the flames are all blue and 
short, close the air shutter.

Too Much Air

Outer Burner Air Shutter Control

(RED)

Left = Less Air

Right = More Air

Center Burner Air Shutter Control

(GOLD)

Left = Less Air

Right = More Air

: you may wish to use pliers to adjust the front 

air shutter.  Typically, the front air shutter is fully closed 
(left) on NG, fully open (right) on LP

10.  Turn the flame adjust knob to its highest position - the flames should not contact the top of the firebox.  Check the flame 

on low position.  The flames should burn off of each burner hole.  If the heater does not work correctly, contact your Travis 
dealer for a remedy. 

11.  Give this manual to the home owner for future reference and fully explain operation of this heater.  For comprehensive 

operating and maintenance instructions, refer to the Owner's Manual (part # 100-01219). 

ACID WASH WARNING:  Before installing the faceplate, make sure any masonry that has been treated with acid wash has 
been properly neutralized (this is used primarily with brick faces).  Acid wash (muriatic acid) is used to remove excess mortar.  
If not properly neutralized with an ammonia solution, the plated face may develop a permanent tarnish when the acid 
evaporates over time.  Contact your dealer if uncertain your facing has been properly neutralized.