Справочник Пользователя для John Deere Products & Services OMGX10902 I0

Assembly - 14

2.  Assemble breakover stop bolt:

•

Install one 5/16 x 5/8 in. hex bolt (D) into bottom hole 

of each rib on blade assembly and fasten with 5/16 in. 
lock nut (E).

1. Assemble the pivot plate (A) and the pivot plate 
reinforcement (B) on top of the thrust channel (C).

2. Lubricate thrust channel, pivot plate, and pivot plate 
reinforcement in areas of contact with light multi-purpose 
grease.

3. Insert 5/8 x 1-3/4 in. hex head bolt (D) through the pivot 
plate reinforcement, pivot plate, and the thrust channel and 
fasten with 21/32 x 1-5/16 in. flat washer (E) and 5/8 in. 
nylock nut (F).

4. Loosen 5/8 in. nylock nut approximately 1/4 turn to allow 
the assembly to pivot freely.

1. Lubricate large hole and two faces of pivot release 
bracket (A) with light multi-purpose grease.

2. Assemble idler spring (B) into smallest hole of pivot 
release bracket (A).

3. Place 3/8 in. lock washer (C), 3/8 x 1-1/2 in. flat washer 
(D), pivot release bracket (A), large 1/2 x 2 in. flat washer 
(F), and spacer (E) onto 3/8 x 2-1/2 in. full thread bolt (G).

4. Align holes in thrust channel (H) with pivot plate 
reinforcement (I) and thread 3/8 x 2-1/2 in. full thread bolt 
(G) with parts assembled into hole and tighten securely.

5. Place 3/8 x 1-1/2 in. flat washer (D) onto bottom of 
3/8 x 2-1/2 in. full thread bolt and fasten with 3/8 in. nylock 
nut (J). Loosen nut approximately 1/4 turn until pivot plate 
pivots freely.

6. Hook other end of idler spring (B) to pivot plate 
reinforcement.