Справочник Пользователя для John Deere Products & Services OMGX10902 I0

Assembly - 15

1. Insert 3/8 x 4-1/2 in. full thread bolt (A) through one side 
of thrust channel (B), approximately half way.

2. Assemble one 3/8 in. hex nut (D) (non-locking) and 3/8 
in. lock washer (C) onto hex bolt (A) approximately 1 inch 
from head of bolt.

3. Place two pivot latch straps (E) together and fasten with 
3/8 x 1 in. hex bolt (F) and 3/8 in. nylock nut (G). Insert 
pivot latch straps through slot of the thrust channel and 
onto the hex bolt (A).

4. Assemble second 3/8 in. hex nut (D) and 3/8 in. lock 
washer (C) onto 3/8 x 4-1/2 in. full thread bolt and hand 
tighten against pivot latch straps. Adjust two 3/8 in. hex 
nuts to allow hex bolt (A) to pass through other side of 
thrust channel and fasten bolt with 3/8 in. nylock nut (G).

5. Fasten pivot latch straps (E) in the center of slot of the 
thrust channel with 3/8 in. hex nuts (D).

1. Assemble pivot control rod (A) into pivot latch straps (B) 
and fasten with two cotter pins (C) by inserting each 
through the grooved side of the pivot control rod on each 
side of pivot latch straps.

2. Assemble other end of pivot control rod (A) into hole of 
pivot release bracket (D) and fasten with cotter pin (C).

1. Turn one 5/16 in. nut and lock washer assembly (A) 
onto one 5/16 x 1-1/4 in. hex bolt (B) with lock washers