Справочник Пользователя для John Deere Products & Services OMGX10902 I0

Assembly - 17

1. Install front stabilizer bracket (A) over thrust 
channel (B).

2. Assemble one rear support channel to each side of the 
thrust channel and fasten with four 3/8 x 1 in. hex 
bolts (C) and four 3/8 in. nylock nuts (D) with the head of 
the bolt to the inside. Hand tighten nuts only.

1. Assemble the lift channel (A) to rear support 
channels (B) with the open side of the lift channel upward.

2. Fasten lift channel with two 3/8 x 1 in. hex bolts (C), two 
3/8 x 1 in. flat washers (D), and two 3/8 in. nylock nuts (E). 
Hand tighten nuts only.

3. Slide rear mounting bracket (F) over rear support 
channels (B) with the double holes to the rear and fasten 
with four 3/8 x 1 in. hex bolts (C) and four 3/8 in. nylock 
nuts (E). Hand tighten nuts only.

4. Place rear locating bracket (G) on top of rear mounting 
bracket (F) and fasten with two 3/8 x 1 in. hex bolts (C) and 
two 3/8 in. nylock nuts (E).

5. Tighten all hardware on rear support channels.