Справочник Пользователя для John Deere Products & Services OMGX10902 I0

Installing - 4

Installing

1. Park the machine safely. (See Parking Safely in the 
Safety section.)

2. Install one 1/2 x 1-1/2 x 3/16 in. flat washer (A) onto the 
pin of each lift arm (B).

3. Insert the blank end of the lift arms behind the guide 
rods (C) of the machine lift at each side of machine.

4. Insert the pins of the lift arms into the holes in the frame 
rail (D) of the machine and secure with spring locking pins 
(E).

1. Unlock park brake, put gear transmission in neutral or 
pull out free-wheeling lever and push machine forward until 
rear mounting bracket (A) of blade assembly is behind 
drawbar (B) of machine.

2. Lock park brake.

3. Raise rear of blade frame and slide onto drawbar (C) of 
machine.

4. Fasten with hitch pin (D) and large spring locking pin 
(E).

5. Insert long end of each front stabilizer pin (F) into tube 
of front stabilizer bracket (G).

6. Insert short end of each front stabilizer pin into front 
mower mounting holes located on underside of front axle, 
place spacer (I) over end of pin and secure with spring 
locking pins (H).

1. Put lift lever one notch up from its lowest position.

c