Справочник Пользователя для John Deere Products & Services OMGX10902 I0

Installing - 5

2. Insert threaded end of lift links down through holes in lift 
channel (A) and bent end of lift links through holes in lift 
arms (B).

3. Fasten bent ends of lift links (C) to lift arms with spring 
locking pin.

4. Thread 3/8 in. nylock nut and 5/16 in. flat washer (D), 
one on each side until they seat against lift channel (C).

1. Insert handle end of pivot control handle (A) through eye 
bolt (B) and slide it all the way to bracket end of pivot 
control handle.

2. Hook pivot release rod (C) into hole of bracket at end of 
pivot control handle and fasten with spring clip (D).

3. Lay pivot control handle along side of machine onto 
wheel and footrest of machine. Make sure hook of bracket 
on end of pivot control handle is to the right of the eye bolt.

4. Slide 3/8 x 1 in. flat washer onto handle end of pivot 
control handle and slide all the way to eye bolt.

5. Install spring locking pin (E) through pivot control handle 
to hold washer against eye bolt.

6. Install rubber handle grip (F) to handle of pivot control 
handle.

1. Slide eye of pivot handle support (A) onto pivot control 
handle (B).

2. Insert pivot handle support through 1/2 in. hole in thrust 
channel (C) and place strap over nut (D) of thrust channel. 
Secure with spring locking pin (E) on opposite side of thrust 
channel.