Инструкции По Установке для Gaggenau VI491610
8
Hole for control knobs
The built-in control console can be integrated into the
lower cabinet at drawer level. Panel thickness:
lower cabinet at drawer level. Panel thickness:
5
/
8
" - 1"
(16 - 26 mm)
1
If front panel thickness is greater than 1" (26 mm):
Mill out front panel on rear side to the point that
the thickness doesn't exceed 1" (26 mm). Adjust
the measurements of the milled-out section to fit
the holding plate.
Mill out front panel on rear side to the point that
the thickness doesn't exceed 1" (26 mm). Adjust
the measurements of the milled-out section to fit
the holding plate.
For flush mounting:
2
According to the figure, create the drill holes Ø 1
3
/
8
" (35 mm) for fixing in place the control knobs
in the front side of the lower cabinet. A drilling
template is included for precise positioning of the
drill holes.
template is included for precise positioning of the
drill holes.
For flush mounting:
PLQ
PLQ
[
[
PLQ
PLQ
PLQ
PLQ
[
[
PLQ
PD[
PLQ
PD[