Bosch F.01U.278.516 用户手册
Relay Unit
Programming | en
19
Bosch Security Systems
User Manual
F.01U.278.516 | V1.0 | 2012.11
4.2
First use
4.2.1
List of original factory settings
* Locating mode and identification number are set at first use. To change a value, reset the
4.2.2
Parameters set by the Main Unit
The parameters listed below are programmed in the Main Unit and are applied to the Relay
Unit. See the Main Unit user manual.
–
Display mode
–
Unit language
–
Date and time
–
Local acknowledgement and the access code
–
Output relay function and mode
4.2.3
Locating mode and identification number
1.
Disconnect the Relay Unit from the RS-485 bus.
2.
Switch the Relay Unit on with the switch located at the bottom of the unit. Wait for the
following display to appear:
3.
Enable (ON) or disable (OFF) the indication of the transmitter position (locating mode)
on the Relay Unit display. It must be the same as in the Main Unit.
Press
to disable or
to enable the locating mode.
4.
The identification number of the Relay Unit must now be attributed.
The identification number is attributed by the Main Unit upon connecting the RS-485 bus
corresponds to the order of connection. It can also be set manually. The range for this value is
(A, B, C, ..., Y, Z, a, b, c, d, e, f) for a maximum of 32 Relay Units.
Automatic attribution by the Main Unit
5.a. Press
or the Red button to erase any previous selection. The black box remains.
5.b. Connect the Relay Unit to the RS-485 bus. Press
or the Green button to enable the
automatic attribution. The next free identification number is attributed by the Main Unit and is
displayed on the Relay Unit at the bottom right.
Parameter
Original Factory Setting
Page
* Locating mode
On
* Identification number
No value
Assistance and fire priority
No
Speaker volume
Midrange
LOCATING ?
( OFF / ON
)
RELAY UNIT ID: ·
( +
/ -
)