Bosch F.01U.278.516 用户手册
20
en | Programming
Relay Unit
F.01U.278.516 | V1.0 | 2012.11
User Manual
Bosch Security Systems
Manual selection of the Main Unit
5.a. Scroll with
and
to set manually the identification number. Confirm with
or the Green button. The Relay Unit signalizes that it is not connected to the RS-485 bus.
5.b. Connect the Relay Unit to the RS-485 bus. The number is now visible at bottom right.
4.3
Special settings
After pressing
three times quickly, you can enter special codes.
4.3.1
Displaying the firmware version
Type the code 194155. The version of the firmware will be displayed for a few seconds.
4.3.2
Resetting all the parameters and buffers
Type the code 194156. The unit resets, plays a melody and displays a message:
After a few seconds, the unit goes back to the first use display.
Select the locating mode and the identification number. See Section 4.2 First use.
4.3.3
Assistance and fire priority
This sets the assistance call and the fire alarm as priority calls, that will be displayed first.
Type the code 123991. The unit plays a melody and a confirmation message is displayed.
4.3.4
Assistance and fire non priority
This command sets the assistance call and the fire alarm as non-priority calls. This means that
the last alarm is displayed, whatever its type. This is the default value.
Type the code 123992. The unit plays a melody and a confirmation message is displayed.
RELAY UNIT OFF !!!
Enter Code
Software
REV
A
V2.02 BN111.242.00A
NOTICE!
This resets the Relay Unit to its original factory settings, erasing all the parameters, alarms
and events buffers. It is mandatory if you change the locating mode or the identification
number. Disconnect the RS-485 bus before performing a reset. Reconnect it afterwards.
Please Wait...
ASSISTANCE & FIRE
PRIORITY
ASSISTANCE & FIRE
NONPRIORITY