Quantum acl 4 安装指导

Chapter 2 Unpacking the Library
Packing the Library for Shipment

18

ACL 4/52 Facilities Planning and Installation Guide

2

To unload the library:

1 Remove all tapes from the fixed storage bins.

To do this, grasp the exposed end of each tape and lift it out of the 
bin. 

2 Remove any tapes in the load port bins.

Load port bins are accessible from inside the library. To remove a 
tape from the load port, grasp the exposed end and lift it out.

3 Remove any ejected tapes from the tape drives.

4 If you ejected any tapes prior to turning off the library, they may be 

in the drive slots. Remove each tape carefully from the drive; make 
sure the tape is completely unloaded (not buckled to the take-up 
leader) before completely removing it.

5 For more information, refer to the ACL 4/52 Operator’s Guide.

2

To install the packing materials:

1 Install the foam blocks as shown in figure 12 on page 14 and 

explained below:

a

Gently raise the vertical carriage and place the vertical carriage 
foam block into position. Lower the vertical carriage onto the 
foam block.

b

Install both the top and bottom horizontal carriage foam 
blocks.

c

Gently slide the horizontal carriage toward the back of the 
library and against the horizontal carriage foam blocks.

2 Install four tie-wraps to secure the extension axis, the vertical 

carriage, and the horizontal carriage as shown in figure 11 on 
page 13 and explained below: 

a

Route the two horizontal carriage tie-wraps through the notch 
on the vertical rail and secure them through the notch on the 
frame.

b

Route the extension axis tie-wrap around and back up through 
the extension axis platform and secure it around the gripper 
motor.

Do not route the tie-wrap over the gripper motor power cable.

c

Route the vertical axis tie-wrap under the bumper standoff and 
secure it around the extension axis platform.