KitchenAid 36" Convertible Under-Cabinet Hood 安装指南

 

■

Remove screws and rear support.

 

■

Remove the blower mounting screws. Push up on the 

blower to detach the blower from the mounting plate.

 

■

Remove the vent knockout from the front mounting plate.

 

■

Rotate the blower and attach to front mounting 

plate. Install the blower mounting screws.

 

■

Install charcoal filters. See the “Range Hood 

Care” section.

8.  Using 2 people, lift range hood into final position, feeding 

electrical wire through wiring opening. Position the range 

hood so that the large end of the keyhole slots are over 

the screws. Then push the hood toward the wall so that 

the screws are in the neck of the slots. Tighten mounting 

screws to cabinet, making sure mounting screws are in 

narrow neck of slots.

9.  Check that damper, if used, rotates up and down freely.

10. Reinstall the rear support.
11. Replace the 2 lateral supports.
12. Replace filters. See the “Range Hood Care” section.

13. Plug 3 prong power cord into a grounded 3 prong outlet 

located inside the cabinet above the range hood.

Connect ventwork to hood. Seal joints with clamps 

to make secure and airtight.

Complete Installation

1.  Replace grease filters. See the “Range Hood Care” section.
2.  Check the operation of the range hood fan and light. 

See “Range Hood Use” section.
If range hood does not operate, check to see whether a 

circuit breaker has tripped or a household fuse has blown. 

Disconnect power and check wiring connections.

NOTE: To get the most efficient use from your new range 

hood, read the “Range Hood Use” section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking 

vapors and odors from the cooktop area. For best results, 

start the hood before cooking and allow it to operate several 

minutes after the cooking is complete to clear all smoke and 

odors from the kitchen.
The hood controls are located on the center of the range hood.