KitchenAid 36" Convertible Under-Cabinet Hood 安装指南

Install Range Hood

1.  Remove the grease filters. See the “Range 

Hood Care” section.

2.  Remove mounting screws and lateral supports.

 

■

Depending on your installation, remove either top 

or rear rectangular vent knockout. If using round 

vent, remove top rectangular knockout.
NOTE: Do not remove rectangular knockouts 

if installation of range hood is to be non-venting 

(recirculating).

 

■

Make sure damper pivot is nearest to top/back 

edge of range hood.

 

■

Remove tape from damper flap.
NOTE: The exhaust adaptor/damper can be 

installed up to 1" (2.5 cm) on either side of the 

hood center to accommodate off-center ductwork.

 

■

If using rectangular vent, attach rectangular damper/vent 

connectors to the range hood using sheet metal screws.

 

■

If using round vent, attach vent transition piece 

(purchased separately) to range hood top using 

sheet metal screws.
NOTE: If the wall cap is directly behind the vent 

connector, the dampers in the connector and 

wall cap must not interfere with each other. 

Remove the vent connector damper if they interfere.

4.  Lift the range hood up under cabinet and determine 

final location by centering beneath cabinet. Mark on 

the underside of cabinet the location of the 4 keyhole 

mounting slots on the range hood. Set range hood 

aside on a covered surface.

5.  Use 

1

/

8

" (3 mm) drill bit and drill 4 pilot holes as shown.

6.  Install the 4 - #10 x 

5

/

8

" mounting screws in pilot holes. 

Leave about 

1

/

4

" (6.4 mm) space between screw heads 

and cabinet to slide range hood into place.