KitchenAid 36" Convertible Under-Cabinet Hood 安装指南

Range Hood Controls

The On/Off light button controls both lights. Press once 

for On and again for Off.

The Blower Speed buttons turn the blower On and control 

the blower speed and sound level for quiet operation. The 

speed can be changed anytime during fan operation by 

pressing the desired blower speed button.
The Blower Off button turns the blower Off.

RANGE HOOD CARE

Cleaning

IMPORTANT: Clean the hood and grease filters frequently 

according to the following instructions. Replace grease 

filters before operating hood.

To avoid damage to the exterior surface, do not use 

steel wool or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:

 

■

Liquid detergent soap and water, or all-purpose cleanser

 

■

Wipe with damp soft cloth or nonabrasive sponge, 

and then rinse with clean water and wipe dry.

1.  Remove each filter by pulling the spring release handle 

and then pulling down the filter.

2.  Wash metal filters as needed in dishwasher 

or hot detergent solution.

3.  Reinstall the filter by making sure the spring release handles 

are toward the front. Insert aluminum filter into upper track.

4.  Push in spring release handle.
5.  Push up on metal filter and release handle to latch into place.
6.  Repeat steps 1 through 5 for the other filter.

The charcoal filter is not washable. It should last up to six 

months with normal use. Replace with Charcoal Filter Kit 

Number W10272068.
To replace charcoal filter:
1.  Cover the grille that covers the blower motor with the 

charcoal filter so that the slots on the filter correspond 

to the pins on the sides of the motor cover grille.

2.  Turn the charcoal filter clockwise to lock it.
3.  Repeat steps 1 through 2 on the other filter.

Turn off the range hood and allow the halogen lamp to cool. 

To avoid damage or decreasing the life of the new lamp, 

do not touch lamp with bare fingers. Replace lamp, using 

tissue or wearing cotton gloves to handle lamp.
If new lights do not operate, make sure the lamps are inserted 

correctly before calling service.
1.  Disconnect power.
2.  Use a flat-blade screwdriver and gently pry the 

light cover loose.

3.  Remove the lamp and replace with a 120-volt, 40-watt 

maximum, halogen lamp made for a G-9 base.

4.  Replace the light cover.
5.  Reconnect power.