Redline Communications Inc. AN30 用户手册

 

 

AN-30 System User Manual 

 

1 Rx 

+ 

2 Rx 

- 

3 Tx 

+ 

6 Tx 

- 

 

 
 
Now connect the DC or AC cord to the AN-30 outlet and turn the terminal on using the 
toggle switch at the rear of the unit. The system “Pwr” LED should illuminate green to 
indicate power to the unit. The system is now ready to be configured.  If the Pwr LED is 
not on and/or the “Fault” LED illuminates red, there is a problem with the terminal. 
 
 
 

 
Once the antenna is mounted and the terminal is installed, the antenna must be aligned in 
both the azimuth and elevation planes.  Elevation alignment is accomplished by 
loosening the two bolts attached to the mounting bracket, as shown in Figure 13 below, 
and angling the antenna so it is aligned towards the remote terminal.  The azimuth 
alignment is accomplished by loosening the bolts on the antenna bracket and rotating the 
antenna until alignment is achieved. For basic tuning using actual signal strength, an 
alignment "buzzer" (intermittent tone sweep generator) is available on the T-58 
Transceiver.  Faster repetitions of the tone sweep indicate better alignment. The buzzer is 
enabled via the software interface described in section 0.   
 

 

Azimuth Adjustment  
Bolts 

Elevation Adjustment 
Bolts 

 

 
 

Page 25 of 80 

Redline Communications