Bosch Appliances Home Security System DS7400XIV4-EXP 用户手册

DS7400XiV4-EXP | User Guide | 6.0   Day to Day Operations 

EN | 12 

 

 

Bosch Security Systems | 6/05 | 4998154961B 

 

6.1.6 Normal 

Disarming 

Please read Section 7.0 Emergency Procedures on page 19 before you are confronted with an emergency event. If you 
entered the building through a perimeter door, you might hear a steady entry alert tone from the wired keypads. 
If so, disarm according to the chart below. 

 

 

If an alarm occurred sometime before your arrival, one or more of these happens:  

• 

The bells and sirens sound. 

• 

The wired keypads issue a pulsed tone during the entry delay instead of the usual steady tone. 

• 

The red Armed LED on any LED keypad flashes. 

• 

The red Armed LED on any text keypad flashes and “Zone Alarm” is displayed. 

If the alarm is not yet investigated, do not enter the building unless accompanied by the appropriate 
Emergency Services’ personnel. 

 

Table 8:  Normal Disarming 

 

 

 

 

Equipment  

Command Sequence 

What Happens 

What To Do 

Text Keypad LED 
Keypad 

[PIN][Off] 

•  The red Armed LED turns off. 

•  All sounders are silenced. 

•  All zones are disarmed. 

•  A single beep sounds. 

•  If a fire alarm was sounding, 

“Sounder Silenced” is displayed until 
the system is reset. * 

•  Determine why the sounders, if 

any, were activated. 

•  Correct the cause. 

•  If a fire alarm was sounding, 

correct the cause and press 
[System Reset] or [#][4][7] to 
reset the system. 

RF3341 Keypad 

[PIN][#]  

•  The LED flashes indicating a signal 

was sent to your security system. 

•  All sounders are silenced. 

•  All zones are disarmed. 

•  Determine why the sounders, if 

any, were activated. 

•  Correct the cause. 

•  If a fire alarm was sounding, 

correct the cause and press 
[System Reset] or [#][4][7] to 
reset the system. 

RF3332/RF3332E 
RF3334/RF3334E 

Press DISARM 
(unlock) button 

•  The LED flashes indicating a signal 

was sent to your security system. 

•  All sounders are silenced. 

•  All zones are disarmed. 

•  Determine why the sounders, if 

any, were activated. 

•  Correct the cause. 

•  If a fire alarm was sounding, 

correct the cause and press 
[System Reset] or [#][4][7] to 
reset the system. 

* Text Keypad only 

Note: When in Commercial Fire Mode, enter [PIN][#] a second time on a text or LED keypad to 
locate the fire zone number(s) in alarm.