Toshiba IPedge IP Telephone 用户手册

IPedge
The Basics

26

While on a call you can perform the following:

Press 

Spkr and place the handset on-hook to switch from handset to 

speakerphone mode.

Take the handset off-hook to switch from speakerphone to handset mode.

This button toggles between Mic and Mute. When Mic button is lit, handsfree 
communication is supported, when Mic is pressed again and light is off, Mute 
is enabled and mutes both the microphone and the handset.

To place a call on hold, press 

Hold. Your LCD shows the line on hold. The 

held Line’s LED flashes green while appearances of the line at other stations 
flash red.

To return to the held call, press the flashing held 

Line button.

If you do not return to the held call within a specified time, it rings back to 
your telephone. The call remains camped-on to your station.

If the held party hangs up, the call is released.

See the Call Pickup section to pick up a call on hold from another 
extension.

This feature enables you to place a call on hold so that only you can retrieve 
it.

While on a call, press 

Hold twice. That line’s LED flashes green while 

appearances of the line at other stations are steady red (in use).

This features enables you to move from one Line button to another Line 
button without pressing Hold. 

Check with your System Administrator to make sure this setting is turned on. 
If Automatic Hold is not enabled, calls will drop when moving from one line to 
another without pressing Hold. 

While on a call, press another extension button to receive/originate a new 
call. The accessed line’s LED flashes (in-use). The first call is put on hold and 
your extension’s LED flashes.

1. While on a call, press 

Cnf/Trn. The call goes on hold.

2. Dial another line.

3. Transfer the call or return to the held call by pressing its 

Line button.