Toshiba IPedge IP Telephone 用户手册

27

Use your 

Msg LED/button and LCD to see/retrieve message(s).

An extension can receive up to four simultaneous Message Waiting indications 
and LCD messages. One message is reserved for the Message Center.

Your telephone can be programmed to have up to four additional (flexible) 
Message Waiting buttons/LEDs. Check with your System Administrator to see if 
these buttons have been programmed on your telephone. If so, substitute them 
when the 

Msg button/LED is mentioned in the following steps.

1. On an LCD telephone, if you see a “+,” press 

SK3 to display additional 

messages; otherwise, go to Step 2. The “+” indicates additional messages. 
The LCD can show up to three station messages for your extension and three 
for each additional (phantom) extension that you may have.

2. Press 

Msg, then lift the handset. Your telephone rings the extension or voice 

mail device that sent the indication. The LED continues to flash red. 

3. After answering the message(s), place the handset back on-hook.
4. If the Msg LED continues to flash, you have more messages; repeat Steps 

1~3 above to retrieve them. Voice mail devices turn off the LED/LCD 
indications after a short delay, after you checked all messages.

5. To manually turn off your Msg LED, press your extension button, then press 

#409. Do this step for each message received.

If you call an extension and it’s busy or there is no answer, you may be able to 
light that extension’s Message Waiting LED and enable that extension to call you 
back. The ability to perform this feature is set in system programming.

1. Dial an internal extension. You hear busy tone or there’s no answer.

2. Press 

Msg or 7. The Msg LED flashes red on the called telephone. At your 

telephone, the Msg LED lights steady red and the LCD shows the station 
number where you set a Message Waiting light. Example: “MW SET TO 
3620.”

3. If you decide to cancel the Message Waiting light at this point, press 

Msg or 7 

again while ring-over tone is playing and the light will be cancelled.

4. Press 

Spkr. Your Msg LED turns Off. The Msg LED on the called telephone 

flashes until the called party presses the flashing 

Msg button which calls you 

back.

5. To turn Off a Message LED that you have set on another extension, press 

#64 plus the extension number that has the message light set. Then press 

Spkr or hang up to release your telephone. Your LCD shows the extension 

and “MW CANCEL.”

...or dial the extension that you set the Message LED on, then press 

. Then press 

 or hang up to release your telephone.