Ericsson T18d Betriebsanweisung

Getting Started

9

Complete the following procedures to set up your 
mobile phone for the first time:

• Review the document conventions used in this 

guide by referring to the “Document Conventions” 
chapter.

• Attach the belt clip to the phone by referring to the 

Attaching the Belt Clip to Your Phone section in 
this chapter.

• Fully charge and condition your battery by refer-

ring to the Charging Your Battery section in this 
chapter.

• Turn your phone On by referring to the “Basic 

Operations” chapter.

Your Ericsson mobile phone is equipped with either a 
standard or swivel belt clip:

Remove the belt clip from the plastic bag.

Remove the flexible rubber plug from the top of the 
clip.

While making sure that the screw is going through 
both the plastic clip and through the metal support 
guide, insert the screw into the opening on the back 
of the phone. 

Using a small Philips head 
screwdriver, turn the screw 
clockwise until it is secure as 
shown in the following illus-
tration. Do not over tighten 
the screw.

Inserting the two smaller prongs first, replace the 
flexible rubber plug at the top of the clip.

Align the screw-in tab 
between the two guides on 
the back of the phone, with 
the thicker end on top.

Using a screwdriver, attach 
the tab to the phone.

Place the swivel belt clip on 
your belt or waistband.

Slide your phone, with tab, into the swivel belt clip. 
To remove, press the release mechanism on the top 
of the clip and slide the phone up and out of the 
clip.

Getting Started

    Push to
release phone