Motorola G24 Benutzerhandbuch
Modem Configuration and Profile
3-286
AT Commands Reference Manual
December 31, 2007
The following table shows the S24 parameters.
Example
ATS24? <enter>
000
OK
ATS24=5 <enter>
OK
ATS24? <enter>
005
OK
(If there are no radio and UART activities, the G24 will enter sleep mode in 5 seconds)
S102, Set Delay Before Sending Data to the Terminal
This command sets the value of the delay before sending data to the terminal. Before receiving
data, the terminal connected to the G24 will receive:
data, the terminal connected to the G24 will receive:
•
Terminal Wakeup signal (the Wakeup Out Line (pin #26) state will be active low).
•
A delay that is equal ATS102 value.
•
Data (GPRS, CSD, AT commands' echo and results, unsolicited reports).
Command Type
Syntax
Response/Action
Remarks
Set
ATS24=[<value>]
OK
The Set command sets the amount of
time, in seconds, the G24 should wait
before entering Sleep mode.
time, in seconds, the G24 should wait
before entering Sleep mode.
Read
ATS24?
<value>
OK
The Read command returns the current
value.
value.
Table 3-189: S24 Parameters
<Parameter>
Description
<value>
Number of seconds (0 <= n <= 255)
0
0
Disable Sleep mode
>0
Enable Sleep mode
The default value is 0.