Harman Stove Company P35I Benutzerhandbuch

Save These Instructions 3-90-775 Pellets or Corn/Pellet Mixture Only

P35i Fireplace Insert

Room sensor placed here gives an accurate measure of return air.

Push the pre-cut hole inward, and feed the sensor from the back

side. Allow the bulb of the sensor to extend approximately 1½

inches into the room. Use a wire tie on the push-in tab to secure

the sensor wire.

G. Control Board Installation

The control board is packaged in a static resistant

bag. Use care when handling, hold the circuit board

only by the edges. In a large fireplace opening, you

may have plenty of space for the circuit board to re-

main attached. For a smaller fireplace opening, you'll

likely need to remove the wiring from the circuit board

to route it through the side of the mounting frame and

out through the control opening. Follow these steps;

• Disconnect the 11 pin harness plug.

• Disconnect the red twisted ESP wire.

• Feed the harness wires and the ESP wire through

the opening in the mounting frame and out

through the control opening in the surround panel.

• Holding the control board outside the opening in

the surround panel, re-attach the harness plug

and the ESP wire.

• After determining the location of the Room Sen-

sor (See next Section), Attach it to the two male

spade terminals near the top of the circuit board.

NOTE: These connections are not polarity specific.

• From the power cord, attach the green ground

wire to the grounding post located on the feeder

air intake snout.

• The black wire from the power cord gets attached

to the short brown wire from the control harness

• The white wire from the power cord will attach to

the short white wire on the control harness.

• Install the control panel into the surround; Right

side first, then tilt in the left side.

• Secure using the four black machine screws in-

cluded with the surround.

H. Room Sensor Installation

Although not required, it is recommended that the

room sensor be connected in every installation. Using

a minimum size 18 gauge wire, you may splice in an

additional length, to extend the room sensor. The fol-

lowing are typical locations for the room sensor;

• On an interior wall next to or in place of a typical

wall thermostat.

• On the leg of a coffee table or end table in your

favorite sitting location.

• Sticking out through the punched hole at the lower

right corner of the control panel.

Note: When installing the room sensor externally,

limit the distance from the stove to 25 feet or less.
Once the location has been decided, run the wiring to

the control panel. You'll need to remove the two ter-

minals from the end of the sensor cable and replace

them with the two smaller terminals from the hardware

bag. Plug the terminals into the circuit board. These

connections are not polarity specific.

Note: If the room sensor is located too close to

the appliance, or in a direct path of the distribu-

tion air, You may need to elevate the temperature

setting to maintain a comfortable temperature

level throughout the heated space.

See Draft Test Procedure on Page 26.

F. Installing the Body into the

Mounting Frame

The rollers on the sides of the insert body will ride on

the rails of the mounting frame. Once the body is all

the way in, hook and close the top spring latches on

each side to secure.