Harman Stove Company P35I Benutzerhandbuch

20

Pellets or Corn/Pellet Mixture Only                                           3-90-775                                                                           Save These Instructions

Most importantly, the frame must be level. Again, be 

certain that the surround is not supporting the weight. 

Turn the leveling screws in until there is a slight gap 

beneath the surround panels. 

Here are a few different ways to anchor the mounting 

frame. 

On the sides of the frame, there are a few holes which 

can be used to attach metal straps. These straps 

can be anchored into the 

fireplace using masonry 

anchors. You could also 

use any of the unused 

holes in the bottom of the 

frame to install anchors 

and lag bolts. Another 

option involves using kit # 

1-00-774279. Here, you will 

mount plates to the frame. 

These plates have coupling 

nuts welded to them. The 

kit also includes two pieces 

of 1/2" all thread, which threads into the coupling nuts. 

These can be used to tighten upward against the lintel 

until the unit is secure.

The flue collar on the rear of the mounting frame is 

designed to pivot. Loosen the four mounting bolts 

and adjust the angle of the collar as needed. Shown 

above is the vertical position and the horizontal 

position. Be sure the fiber gasket remains in place 

between the collar and the mounting frame, and 

secure the bolts. Secure the first section of venting 

to the collar with a minimum of two fasteners. Self-

drilling screws will work well for this. Once the 

venting is secured and the seams are sealed, it is 

recommended that you wrap the vent pipe with a 

non-combustible insulation to prevent overheating of 

the motors and other appliance components. This is 

required (and supplied) when using the optional Zero 

Clearance Cabinet.

There are four (4) holes located as shown, that are 

threaded for 5/16 - 18 bolts. Thread the bolts down 

through the holes to raise the frame corners as 

needed, to level. 

Straps could 

attach here

NOTE: When installed in a rear vent configuration, the maximum BTU 

may be reduced due to elevated ESP temperatures associated with the 

horizontal exhaust stream.