Harman Stove Company P35I Benutzerhandbuch

19

Save These Instructions                                                                    3-90-775                                               Pellets or Corn/Pellet Mixture Only

The surround consists of three panels, the top and 

two sides. Follow these steps for installation:

1.  Remove the insert body from the mounting frame; 

2.   Start your leveling bolts into the floor of the frame    

      and adjust to slightly raise the height.(see next           

      section) This will allow some clearance to     

    

      assemble the surround. 

3.   Prepare the side panels by removing three nuts   

      each. The left side panel is the one with the control   

      board opening. If mounting the control door, the     

      hinge bracket will attach using the control panel      

      mounting screws. 

4.   Attach the side panels to the mounting frame by  

      guiding the threaded studs through the holes in   

      the mounting frame. Slip the power cord ground  

      wire terminal over the bottom stud on the left side.  

      Install the nuts onto the studs, finger tighten only.

5.   Install the top panel, making sure to close the gap    

      with the side panels first. Tighten the nuts on the   

      splice brackets securely. 

6.   Set the mounting frame into position in the   

   

      fireplace opening. Be sure the surround panel is    

      raised slightly so that it is not supporting any of the   

      weight of the mounting frame.

7.   When pleased with the alignment, tighten all of the   

      nuts securely.

8.  There are two more holes in the splice brackets to    

      align the outer sides of the surround panel joints. If   

      desired, install the supplied black pop-rivets here.

When choosing an electrical supply outlet, be sure 

the polarity is correct, and that the supplied voltage is 

within the range of 117 to 123 Volts. Surge protection 

is also recommended to protect the control board 

software in the event of a surge or spike. 

Once the outlet location is decided, you'll need to 

install and route the power cord. 

At the bottom of each of the side surround panels 

is a knockout for the cord retainer. Remove the 

appropriate knockout and feed 

the loose wire end of the cord 

into the hole. If your cord needs 

to exit from the right side, route 

the cord up the side and over 

the top of the mounting frame 

and back down the left side. 

Attach the ground wire ring 

terminal to the bottom stud 

on the left, and use the two 

hooks on the top corners of 

the mounting frame to secure 

the cord. Slip the cord clamp onto the cord right in 

front of the opening in the side panel. Using a pliers, 

compress the cord clamp and push it into the hole.